About AutomateSHANE

Sure, here is the trace with encryption turned off. ... View more

@NoRisk4Project I have no control over the behaviour of the Optix OPC UA client. I am at the mercy of the developers. Recently I did receive feedback from a liason in regards to that warning message. They say that your server is actually not following the specs, which is very common with Bosch and Siemens "which are using references in the wrong way, trying to parse the whole tree and fixing such references." If I had a different OPC UA server available to test with, I would. Unfortunately, I do not. Attached is the requested Wireshark capture. ... View more

I don't believe so. The IP packets from your PC need to be forwarded from the incoming port on the ctrlX CORE to the port of the ECAT master. Even if there were a way to set up NAT on the CORE to translate the ECAT master EoE IP address, it would not work because your PC is trying to communicate with the SAFEX, not the ECAT master. This is why the routing table of your PC needs to know that the traffic to the SAFEX is intended to be routed through the ctrlX CORE as a gateway.  ... View more

It's interesting to me. I did a project with some AL1333 and IO-Link devices and I don't remember if I tried AoE or not. I ended up using CoE to access the IO-Link paramter data using SDO reads and writes. It worked fine, without speed isues. The PLC code is just less simple. ... View more

Hi. Are you able to provide an update now? It has been quite some time. I have not seen new firmware since last year. The workaround using PLC code works ok, but it means the PLC must be stopped (or the program inhibited) if you want to force the whole bus to Init from I/O Engineering.  ... View more