About AutomateSHANE

AutomateSHANE · ‎04-25-2024

@Sgilk , Unfortunately, it is too late for that. I had done a factory reset on my CORE because I couldn't waste any more time. After the reset, I restored from my backup but the problem still persisted. I reflashed, using the 1.20.12 systemimage and re-installed all the apps using the latest downloadable apps package. Forwarding has worked just as it should since then. If I had to make an educated guess on which version I was at previously, I would say it was the same as the one you originally tested, XCR-V-0120.4

AutomateSHANE · ‎04-16-2024

I've taken a look at several samples now and a lot of references across different sites. I have a slightly better understanding of how this all pieces together, but I'm still quite lost on my next steps. Honestly, the 'How-To' here doesn't have any 'how'. It is a great show-and-tell and general introduction, but those of us who are new to Docker and have self-taught software skills need a bit more than just finished examples that must be reverse engineered. There's way too many pieces to this puzzle.

AutomateSHANE · ‎04-15-2024

@Sgilk , After a lengthy process, I finally have a user assertion. It is uploaded and SSH active. What now?

AutomateSHANE · ‎04-08-2024

It's not because of my PC. I had already ruled that out once, but I just did it again. Using a PC that isn't on a domain, and with Windows firewall turned off, I set up the addresses and routing and...no change. It too can see the other interface of the CORE, but not the device on that subnet.

AutomateSHANE · ‎04-08-2024

I activated SSH.

About AutomateSHANE

Re: CORE X3 Not IP Forwarding

Re: Help snapping a Docker image

Re: CORE X3 Not IP Forwarding

Re: CORE X3 Not IP Forwarding

Re: CORE X3 Not IP Forwarding