About Servodude

Servodude · ‎10-10-2022

Sorry, I mis that one. I was looking in the mains voltage and DC bus tables. But using the search function I can not find the corresponding netfilter, only the filter for the 3 phase mains voltage. New to me but which netfilter should I use for 1-phase mains voltage on a XCS2-W0023 drive, is the NFE02 fpr the HCS01 drive usable ? In total 8 drives with total 80 m motorcable, total continues power approx. 1 kW Servodude

Servodude · ‎10-06-2022

Hello, finding in the planning manual that it is possible to operated on a 1x230V supply voltage with the ctrlX Drive, so fare so good But I have tried to find out what requirements are need, thinking of filters, max cable lenghts etc ? Also what is the continous and maximum current output ? Still the same, e.g. 6/23 A for the XCS0023 drives ? Trying to use the configurator doestnt help, since it only shows 3x200-500V supply voltage but not possible to select 1x230V Servodude

Servodude · ‎09-28-2022

Hello, I have the same case. Is there any other possibilities when the requirement at this moment is small framesizes and 1x230 supply voltage ? Servodude

Servodude · ‎09-23-2022

Hello all, A question regarding Profinet IR and ctrlX drive, if that works together ? Situation is a customer using a Siemens S7-1500 and S210 drives. Communicaton between is done with Profinet IR. The functionality is in the PLC performing positioning (1 drive), electrical gearing (2 drives) and torque control (1 drive) by sending the setpoint to the drives. Is it possible to replace the S210 drives with our ctrlX Drive with Profinet option ? What if STO over Profisafe also is a requirement ? What is your recommendation and experience ? Best regards

Servodude · ‎09-23-2022

Hello everyone, I found in the CodeSys Store the following from BE.Services POWERLINK Configuration Editor This product allows the configuration of POWERLINK networks. Article no. 000086 Industrial Control Systems implementing CODESYS can easily be turned into a POWERLINK Master (Managing Node – MN). The integration of the free open source openPOWERLINK stack and the additional CODESYS Runtime components from BE.services allow full support of the POWERLINK technology. The configuration of the POWERLINK network is available, fully integrated in CODESYS, with this package. Anybody heard of it and if possible if it is possible to run on the ctrlX Core ? The application is controlling frequency inverters on a powerlink network, where it is not possible to change the controller. Therefor the idea is to use our ctrlX core as a gateway between Powerlink and Ethercat, which would be a possibility to run on our EFC inverters. Best regards

About Servodude

Re: Requirements for 1x230V supply voltage operati...

Requirements for 1x230V supply voltage operations

Re: ctrlX Drive with MSM servo motors

Profinet IR and ctrlX Drive

POWERLINK Configuration Editor