About Michael_A

Michael_A · ‎06-15-2023

Hello, until now it is not possible to use torque mode with axisinterface beacuse there are no commands for torque implemented in the motion. The only way to use torque in the drive would be to handle the drive as an io and control it completely from plc side.

Michael_A · ‎06-14-2023

Hello, this restriction will fall with RM2307. Until then it will not be possible to change the Axis ID

Michael_A · ‎04-26-2023

Hello, in your case you will get an error reaction from motion after you try to switch on the axis with the F8022. To get more information, independant from motion, you can use the DriveConnect-App. This will bring you error-messages to the logbook as soon as they appear.

Michael_A · ‎04-18-2023

Hello, try to connect your Device directly to your laptop/pc and then start ctrlX WORKS and take a look there on the devices page. Your device should be visible here. Click on the name (not the IP) of the device and try to connect. Use first XF10.

Michael_A · ‎03-24-2023

Ok, at the moment i can not see any problems with the configuration. May be the axisprofile has a problem with reading the parameter. I will try to clarify on monday.

About Michael_A

Re: Torque Control with AxisInterface

Re: Add a 4th linear axis to a kinematic.

Re: No error feedback of drive failure F8022

Re: CtrlX Core no longer responding to ping after restart

Re: Problem with axis profile