About Dias

Dias · ‎01-03-2023

Please check the table 90: This gives you a good overview

Dias · ‎09-23-2022

Topology example Topology Remote access via Profinet for Diagnostic and Programm changes Before you can have a remote access to the SAFEX-C.15 the Profinet must be configured and must be run. Now the Profinet IO Controller has to be configued. Configuration Profinet IO Controler Configure your Network from your PC Configure your Network Configure the Connection settings of the SAFEX-C.15 Plug your Engineering PC to the Profinet like shown in the Topology. Configure the Connection settings of the SAFEX-C.15 Now you can connect.

Dias · ‎07-07-2022

Hello Guys, I made a short test with 1.12.3, her is my short summary: At first you need a licence for your ctrlX CORE: I create a small test programm with a small visu: And at last you must know how you call the WebVisu I found this information in a CodeSys-Forum: And it works also after a reboot I think it should also works with Version 1.14 I hope this is helpfull

Dias · ‎05-25-2022

see also: https://developer.community.boschrexroth.com/t5/Store-and-How-to/Get-Ethercat-diagnosis-from-ctrlX-CORE/ba-p/57194

Dias · ‎05-24-2022

This Functionblock reads the diagnostic information from Ethercat-Master and tried to find out which Ethercat-Device has an error. In case of fixing the Error a automatic change to state OP will be done The name of the device was written into the variable strSlaveName. If the problem fixed the Ethercat was automatic restarted. You need for this program the library CXA_ETHERCATMASTER. Step 1: Import the attached Functionblock Import the Functionblock Step 2: Call the Functionblock Call the Functionblock Because it is just an diagnosis the cycletime of this task can be slow. In case of an error like break of Ethercat cable, the bit Topology is not OK is comming and the name of Slavedevice which is missing is shown. Check the function You find more details how it works in the comments.

About Dias

Re: Diffrent sample circuts for diffrent performance level

ctrlX SAFETY Engineering remote access to SAFEX-C.15 via Profinet

Re: WebVisu started on port 80, normal hmi not avaiable

Re: Ethercat : Control mode ("init", "OP"...) via JSON/Node red or PLC

Get Ethercat diagnosis from ctrlX CORE into PLC