Snaps for ctrlX CORE Virtual RM 20.07

[bschmidt]

Hello,

Are Motion, PLC, and any other apps available for ctrlX CORE Virtual with RM 20.07? If I try to download the AxisInterface/KinInterface PLC project from the latest ctrlX WORKS of RM 20.07 to the older PLC app from RM 20.04, I get "unresolved external POU references" or similar message that you normally see when the project and and firmware do not match. On the bright side, I copied this example to a real ctrlX CORE project and it is working (after CORE was updated with all the RM 20.07 snaps).

Best regards,

Brian

[Jochen_Mueller · Accepted solution]

Hello Brian

one big point the the RM 20.07:

We have only one app-file for the real/virtual control.

Means you can use the same file to install e.g. motion/PLC/.... either at a real ctrlX or at the virtual ctrlX.

After updating the ctrlX apps you should be able to use the AxisInterface tempalte without error messges....

Regards

Jochen

[bschmidt]

Thanks Jochen, that did work. It didn't work when I tried it previously, but now I realize I was using an old instance of the virtual control. When I made a fresh virtual instance in 20.07, the .app files installed without problem.

Best regards,

Brian