About Sgilk

I meant that the versions you specified should be compatible. There should be no need to change versions, however there is a new major version of 2.15 released at this point. ... View more

Are you sure your Virtual Control is configured to Port Forwarding mode in ctrlX WORKS? Can you please make sure this is the case and then try enabling DHCP for your ipv4 settings on the eth0 interface? With a static IP of 192.168.1.1, it may be that your router is on a different subnet. ... View more

Hi @alnapi , If you reboot, the CORE can you access the runtime manager? If so, could you please download and post the logs under Settings-->Log Settings at the bottom of the page? There is a known incompatability with ctrlX V1.20 and WebIQ V2.13, but this was fixed in V2.14. The versions listed should be compatible. ... View more

@Chai_Student , Wifi connection should be fine. Let's focus on method #1 for now. Once you placed the control in port forwarding mode and on your home network, did you remove the proxy configuration on the control? I recieve a different error in Node-RED with the proxy enabled. Are you using a VPN? If you still recieve this error after disconnecting from VPN and disabling proxy in the control, could you please post an image of your virtual control network interface configuration? ... View more

Can you please let me know which of the following applies to your virtual core? Port forwarding mode and PC is in home network (open internet) No proxy or special settings needed. The control emulation will directly connect to your PCs network and internet (NAT) when booted up. Port forwarding mode and PC is behind corporate proxy (company network) A proxy tool is needed. See below. Port forwarding mode and PC is using VPN A proxy tool is needed. See below. Network adapter mode and PC is connected to home network (open internet) A proxy tool is needed with corresponding IP settings. See below. Depending on your set up, the required configuration will be different. If you are able, connect your PC to a home network, disconnect from VPN, and place the virtual control in port forwarding mode (#1). You should have internet access at that point without the use of a proxy. This is the easiest method. ... View more