About OpconUser

OpconUser · ‎04-10-2024

Hello, could somebody explain what are pre-requesites for using "reset from network" function? I know about these: It can only be used when SAFEX-C.1x is FSoE Slave or PROFISAFE Slave. Only works if it is connected to bit 0 of the F-Bus Input block. But it still doesn't reset alarms when I test it. Project settings are on the attached screenshots. The rest FSOE bits are working correctly.

OpconUser · ‎02-09-2023

I think I could find a solution. If I delete all EDM elements in the whole project then I don't have this compilation error. So if you need to delete one, you probably delete all and add one less back.

OpconUser · ‎02-07-2023

Hello, I have the following error after I delete EDM element from the functional scheme: Could someone help me how can I fix it? And I'm also interested if it is common that software works very slow when I add or remove elements? When I open wiring scheme it takes more than a minute to open the view. We've tried to install software to another laptop, but it was the same slow. Do we need maybe to install something else or to reinstall? I've tried different versions including the latest 8239 with no change of this behaviour.

OpconUser · ‎01-27-2023

Thank you very much, it works now! Could you advice me where can I find documentation describing this commands?

OpconUser · ‎01-27-2023

Everything works fine if I acknowledge error with HMI button in SFKH app. Then I have errors pending, but system is operating, power of axes is on, movements are executed. the errors are: If I acknowledge with /clearerror DataLayer, the state of the axes is following: I hope it's what you've asked. Thank you for support!

About OpconUser

SAFEX reset from network

Re: CtrlX safety engineering EDM element compilation error

CtrlX safety engineering EDM element compilation error

Re: Smart function kit for handling PLC communication

Re: Smart function kit for handling PLC communication