About Hendri

Hello, I am using the Rexroth demo system test bench part number R911398609 - PST-C01.38-01-DE TS CTRLX. I installed the new version of system apps V10 and also updated to the latest firmware to FWA-XD1-AXS-V-0304N. I followed the exact sequence of the document attached but after the update I have been having the following errors. Error log file also attached. Is there something I am missing and how do I clear the errors. I've re-installed all the software already and followed the exact sequence again but with no luck?   ... View more

Why do I get the error "Bad Gateway" when I try logging into the controllers? After closing ctrlX Works and restarting it the error might go away.   Sometimes I have to start ctrlX Works several times. ... View more

I downloaded the latest version of ctrlX Works 1.10.4 When configuring an axis and switching the "Motion operation mode" it goes into "booting" and stays there. When trying to switch it over again I get error messages.     From there I have to delete the Virtual controller and start all over again from scratch. I'm not sure if the new version will allow for a EtherCAT master to be installed, but when I try installing the latest version of EtherCAT master V0110.0, I get the error that a ARM cannot be installed on a ARD? I tried installing older versions that worked with the older version on ctrlX Works but I still get the same error.   Please assist.               ... View more