About georkueh

georkueh · ‎06-20-2023

Is the issue still open?

dhg · ‎06-16-2023

Hello, Yes, the problem was solved as you said: increasing the watchdog on the Siemens. Thank you for the support

georkueh · ‎06-14-2023

Hello, I think you're using ctrlX WORKS 1.20.0. We had a problem, that sometimes the PLC gateway settings made some problems. Please check our new release ctrlX WORKS 1.20.2. This issue should be fixed here. kind regards

danielsimila · ‎06-14-2023

Thank you! Will try as soon as I get the oportunity!

georkueh · ‎06-06-2023

Hello. please increase the watchdog e.g. to 20 for the device at the PROFINET Master. Then it should work with 1ms cycle time at ctrlX CORE too. I don't know how to set it at S7 PN controller, but I added a screenshot of IndraWorks. If there are still some errors you should increase the value once again. kind regards

About georkueh

Re: Codesys SoftMotion and encoder axis

Re: profinet connection not stable

Re: Connection Problems with PLC Engineering - Gateway not configured

Re: Edit plc_system.cfg (Connect Barcode Scanner to PLC project)

Re: ctrlX CORE as PROFINET DEVICE