About sun_lei

sun_lei · ‎05-15-2023

Hello, We try to load basic parameter for more times today and move axis with easystarup mode first and then the ethercat coe communication works o.k for the slave axis. And there is a item need to be check in the datalayer , please see attachment picture. Thanks your support and suggest~

sun_lei · ‎05-08-2023

Hello CodeShepherd The driver always show be CM mode and can transfer to bb status manually by ctrlX Driver engineer. Attachment file is the driver parameter.

sun_lei · ‎05-06-2023

Hello, For the following configuration: ctrlX Drive plus with EtherCAT CoE (Cia402 profile) There is a error message shown for the axis when ethercat communicate transfer from init to OP . The driver firmware is 03v16 , the core runtime is 1.20 , the ethercatmaster app & motion app is 1.20. Some picture in attachment file will show more messages . And the same hardware&app run with ethercat SOE is ok .

sun_lei · ‎11-18-2022

Thanks a lot for your reply~ So,if update the runtime of core first and then do the driver firmware update (0308/0312) ,there is no error message (F8115..) shown ~ (By the way , the sequense is different from "Guideline for the update to XCR-V-0112" ,the manual is shown that for ctrlX DRIVEplus with integrated ctrlX CORE need to do driver firmware first .)

sun_lei · ‎11-17-2022

Hello , There is a error message F8115 shown after update the driver plus(with core) firmware to FWA-XD1-AXS-V-0308N-NN.03 , but the same driver can work base the firmware FWA-XD1-AXS-V-0306N-NN. & FWA-XD1-AXS-V-0304N-NN without error. So is the reason about the limit of the hardware or something else ? the information about the hardware please see attachment file.

About sun_lei

Re: 0x0026 Inconsistent Settings is shown using et...

Re: 0x0026 Inconsistent Settings is shown using et...

0x0026 Inconsistent Settings is shown using etherc...

Re: F8115 is shown after update driver plus firm...

F8115 is shown after update driver plus firmware