About CodeWasi

Setting up a new ctrlX COREvirtual is based on a image and scheduler config which does not fit to your setup by default. Assuming e.g. the motion app was installed and swichting to RUN-Mode is not possible you may struggle because of misfitting configs. Either you can configure the avialbable "app-callables" manually or you Reset the configuration by following button under Manage app data Since the process gets modifcated with the next release we recommend to just click ones the reset-button in the configuation Missfitting Setups - for instance: the installed motion.app is not represented. Booting the motion will never lead to run, since the callable is not called.... After the Reset: In case the reset is performed - dont care about the intergration: Manually setup as an alternative in general: Individual setup ot the callable inside the scheduler config. started with +sign ... View more

Hello ! I downloaded one of these trinamics controller xml description files and the setup worked fine. Please check for the correct XML files. have a look to the attachments, please. Bye Jens ... View more

Assuming:  - the ctrlX is not visible in ctrlX-Works or the Explorer/network and the IPsetup is unknown                   - default setting of "enable DHCP" was not modified by the user in meantime a reset can be avoided if a DHCP server assigns a IP adress to the ctrlX. Instead of placing a router HW to provide the IP-assigning there are several 'DHCP server for PCs available. Exemplarily the following convinced by easy setup and handling. https://www.dhcpserver.de/cms/running_the_server/ Installation and setup described in detail. Once the dynanic adress was given by the DHCP Server, connecting the landing-page is possible and the static-IP adress can be adjusted once again.   ... View more

The operation mode of the (codesys-based) ctrlX_PLCEngineering has 3 different modes to work with. Its ment to prevent the PLC from accidently changes, but most likely only few people did notice so far. If the state becomes changed accidently the investigation may take a while. In case the PLC Logger displays : 'Operation is disabled in current operation mode' its worths to check the operation mode and change it back to Debug.     ... View more