Hello, After enabling the Virtual Ethernet Port for the ethercatmaster in I/O Engineering, changing its address, and downloading the configuration to my ctrlX CORE, I am unable to access the CORE. I have tried pinging the ctrlX CORE, as well as the Virtual Ethernet Port for the ethercatmaster (both the new address and the old one), changing cables, changing computers, pinging another device in the same subnet for reference (which works), but I cannot reach the CORE. I have also tried connecting to it through an USB-C connecter in ctrlX WORKS, but since that proccess also requests an IP address, I cannot succeed. Is my only option to send it back for a factory reset? By the way, as shown below, I am able to see both my ctrlX CORE (192.168.1.1) and the new address for the ethercatmaster (192.168.1.55) with a software for IP scanning, but when pinging them, even then I am not able to connect to either of them.
... View more
Hello, I have made a WinStudio screen in IndraWorks Engineering 15V12 that I want to have running on my VR2109. I am able to connect to it and upload the screen, but the VR2109 does not update any values. I think the problem stems from my OPC UA certificate. I am able to generate one just fine using my computer’s Machine name and use the virtual WinStudio screen in IW15V12, but when I attempt to use the VR2109’s Machine name (“2750” in this case), I run into some problems. Below is shown the various options for when I setup the certificate, the trusted certificate in ctrlX WORKS, and the error message I get, when testing the connection with it afterwards. Any ideas on, what I do wrong? For the VR2109’s Machine name, I have used its Device name, which I could see in its options menu after booting the VR2109. I have also tried changing it with an Admin.ini file on my USB key, but that did not work, either. Thank you.
... View more