About cpedersen

cpedersen · ‎08-12-2021

Hello and thank you for the reply! Just to clarify, there is no way to communicate with the datalayer via MQTT right now? I understand the Node Red app uses MQTT, but there is currently no way to make the ctrtlX Core either a broker/server or an MQTT subscriber?

cpedersen · ‎08-06-2021

There are multiple references on this site to the HiveMQ MQTT program which one should be able to install on the Core. When I search for it in the app store nothign shows up. How do I add it to my core? Thanks.

cpedersen · ‎07-29-2021

In another post it says that only position mode currently exists and velocity mode will be added later. If I have a conveyor that I want to run indefinitely at X meters/second, how would I do that? Would I write arAxisCtrl[AxisNo].PosMode.Position to some impossibly big number and then write arAxisCtrl[AxisNo].PosMode.Velocity to the line speed I want?

cpedersen · ‎07-29-2021

Can you elaborate? Let's say I have a real axis that I want my virtual to sync to. I then want to be able to sync other axis to this virtual axis (a virtual master). Before, I would have vAxis 1 synced to Motor A, and then could sync Motor B and Motor C to vAxis 1. (Motor A -> vAxis1 -> Motor B and C) In the new system, would I have multiple axis connected to the same profile? Would multiple drives have one axis? What should my new system configuration look like?

cpedersen · ‎07-28-2021

This questionmight be better placed in the I/O or Motion sub-forums. In Indraworks one is able to create a virtual axis or virtual encoder and implement it essentially the same as a real axis or encoder. How would I create a virtual axis in ctrlX?

About cpedersen

Re: How to add app zone app to Core?

How to add app zone app to Core?

Commanding a conveyor

Re: Create vAxis in ctrlX?

Create vAxis in ctrlX?