About stefanAT_ctrlX

Drives_Uwe · ‎02-28-2023

There is no need to change the parameter P-0-0853 to a lower value than 950V. The bleeder will correctly be switched on at 730V as parameterized.

FooFighter · ‎02-27-2023

Hello st_ctrlX_user, yes, the setup supports the following parameters: ctrlx-works-1.18.2.exe /Path="{installFolder}" /Mode={mode} /Silent=yes installFolder is the folder to install the product (must be empty for new installation) or direct to an installation folder in case of an update installation mode is either "Install" or "Update" Silent either yes or no Regards, Oliver

stefanAT_ctrlX · ‎02-17-2023

Thank you for the informations ! Oh, yes, I was wrong, I thought to collect data from different devices. You are right, the ctrlX has to be the controller. Or the S7 has to be the Profinet controller and the CORE the device. We check with customer.

TheCodeCaptain · ‎02-15-2023

Hi st_ctrlX_user, the ctlX CORE cannot be a NTP server. But it could act as an router and forward the ntp requests to the outside. To secure it a bit more you could use firewall rules to block all other traffic. Regards

stefanAT_ctrlX · ‎01-03-2023

Nice to know. But another step has to be done. I tried the above mentioned but if I use in a parameter editor window the help it still opens the online help. You have to activate the following: see screenshot. then the "online"-window opens but with the offline-address. Regards, Stefan

About stefanAT_ctrlX

Re: maximal DC Voltage at XCS

Re: ctrlX WORKS installation via command line

Re: Fast reading of data via PROFINET into ctrlX CORE and send it to a database in a fast ...

Re: NTP time synchronisation, ctrlX CORE as a NTP server ?

Re: ctrlX Drive Engineering Local help file by default