FORUM CTRLX AUTOMATION
ctrlX World Partner Apps for ctrlX AUTOMATION
- About mirazchiew
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
About mirazchiew
since
12-19-2022
10-10-2024
mirazchiew
Established Member
19
Posts
1
Likes
2
Solutions
02-17-2023
09:40 AM
Hi Thanks for your help! It did accept the change, but unfortunately the red message from pic 2 remained
... View more
02-16-2023
02:07 PM
Hello, I have a problem with axis profile. I use CANopen over Ethercat stepper drivers. I encountered no difficulties in defining the axis. When defining the signals, I have entered the minimum requirements for the profile to be defined. PIC 1 Unfortunately after trying to start my axis throws an error which can be seen in the picture below. PIC 2 When checking the Data layer, I noticed that the data in the scaling-information is not correct, and I tried several times to enter the correct data, but without success. Every time I make some corrections and write them, it shows me a message that the new data has been saved and after the message disappears, the corrected data goes back to its previous state. Bifore add data: PIC 3 After add data: PIC4 PIC5 I try to download also the configuration file, to adjust these parameters and upload it again. But without success. Can you tell me how I can change this data?
... View more
01-11-2023
01:59 PM
Hi, Actually I already solved my problem. After going through a few CtrlX updates, I'm now on 1.18 and everything is working correctly as far as I can see. Otherwise, before I upgraded to 1.18, when I started CtrlX it gave me the same error. I followed the procedure described above, but unfortunately when I restarted I got the error again. that's exactly why I sent the log file and configuration so that someone can check me or give me some guidance. Thanks for the help anyway, but I think I've solved the problem with the controller upgrade at this stage.
... View more
12-22-2022
09:56 AM
Hello, For me, the above actions do not lead to a specific result. I am sending you the zip file of the configuration as well as the log file.
Please make the appropriate corrections and return them to me.
... View more
- « Previous
- Next »
OK
OK