FORUM CTRLX AUTOMATION
ctrlX World Partner Apps for ctrlX AUTOMATION
- About EngJay
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
About EngJay
since
06-27-2022
17 hours ago
EngJay
Long-established Member
42
Posts
3
Likes
6
Solutions
04-23-2024
09:39 PM
Hi @VincentDruart
I personally prefer IFMs own configuration interface. Consider using the EoE protocol as described in this example: https://developer.community.boschrexroth.com/t5/Store-and-How-to/ifm-IO-Link-Master-DataLine-EoE-configuration/ba-p/55876
Let us know if that works faster!
Best regards,
Jay
... View more
04-16-2024
05:20 PM
Hi Tasty Tech,
Email notification libraries have been in CodeSys for a long time now. So you could go that route with the PLC app, by downloading the necessary libraries/packages from CodeSys. However, considering you already have the IXON app, in my opinion, it is even easier to setup Alarm email notifications through the IXON cloud. See here for reference: https://support.ixon.cloud/hc/en-us/articles/360018155959-Receive-and-filter-incoming-notifications
Best,
Jay
... View more
03-27-2024
12:16 AM
The Snapshot option is for saving all parameters to look at later on (drive parameter S-0-0017). Commision is for backing up all operation data (S-0-0192) and Device firmware. This is useful for serial commissioning of devices. Device replacemnt backs up operation data, firmware, and retain data (p-0-0195) in case you have to replace a specific device.
See the image below for a breakdown chart:
... View more
02-01-2024
04:53 PM
If memory serves, I did try to clean all, but I will review to be sure. For now, of course, I was able to manually assign an open address. I will look to test again with 2.06 in March and update the post. Thanks.
... View more
01-17-2024
12:36 AM
I was using the PLC Datalayer_Realtime feature 'Select realtime data' -> 'selectively from the core' to add status words and dc bus control word for multiple drives.
As you can see in the screen shot below, I get the errors ctrlX_DRIVE_XMD_SoE_1_2_FSoE_7: The address %IW224 is already used and ctrlX_DRIVE_XMD_SoE_1_2_FSoE_7: The address %IW226 is already used. There seems to be a bug where the address locations are not properly auto-assigned and for some reason at this point it reuses the address location of ctrlX_DRIVE_XMD_SoE_2_2_FSoE_6.
I'm using PLC Engineering version 2.4 and attached the version info for reference.
... View more
OK
OK