IndraControl L65 Device Install in Codesys

[AMF]

Hello,

I am trying to add a IndraControl L65 PLC to Codesys and begin programming but I cannot find any library to install it.

Is there something I am doing wrong or looking in the wrong place? I tryied the Bosch Rexroth Website, I installed an EDS but it's mostly for Ethernet from what I've seen.

Need to mention I'm quite the beginner in this PLC world so your advice and patience is highly appreciated.

Thanks,

AM

[CodeWasi]

Hello AndreiMartin,
the former controls like the L-/XM series are not covered by the ctrlX-PLC-Engineering.
These controllers are supported by the engineering tool Indraworks.
The suites are available under : downloads

The corresponding MLC/Indraworks forum available under: Forum

Bye

[AMF]

Thank you for your reply!

Is there anything that I can use aside from IndraWorks? 

I've seen IndraWorks DS but doesnt seem to be the right thing.

AM

[CodeShepherd]

Moved to corresponding sub forum "IndraWorks, IndraControl for MLC/MTX, IndraDrive".

[CodeWasi · Accepted solution]

Hello AndreiMartin,

have a look for Indraworks ML... shall be visible under the link I sent.

The control-hw L65 you mention will be covered by that engineering suite. IW-DS just covers the Drive-setup. 

If you are not familiar with the IW-Engineering, please watch out for the included IW-Help documentary.