About yzpguest

yzpguest · ‎06-05-2024

Thank you very much for your answer. I still have some questions. If the CtrlX device supports these two communication methods: Service Channel: Used for device configuration or parameter setting. It allows access to device parameters through the IDN (Identity Number) for configuring or modifying the parameters of servo drives. Process Data: Used for real-time data exchange, such as control commands and device status feedback. This method supports efficient and low-latency data transmission, suitable for control applications that require a rapid response. If the position under this data layer communicates via the process data pathway If the oscilloscope is synchronized in real time. When the oscilloscope listens to the data. Will there be a delay of five cycles in this case?

yzpguest · ‎06-04-2024

Environmental Introduction Installed app App version and system version Problem Reproduction 1. Select the object to monitor in the oscilloscope. 2. Start monitoring. 3. Perform jogging in Motion. 4. Monitoring through the oscilloscope reveals that the position feedback is delayed by about 5 cycles. 5. This is the result of synchronous capture on the oscilloscope on the driver, showing that it is normal to start returning position feedback within about 1 cycle. Two Ctrlx X2s, one Ctrlx X7, and two Rexroth drives and motors have been used. I would like to know the reason for this and what I should do. Thank you. Attachment: Relevant data from this test on the Ctrlx app oscilloscope and the driver oscilloscope, captured at the same time.

yzpguest · ‎05-29-2024

Thank you for your . The first image was obtained on the ctrlX DRIVE, and the second image was obtained on the ctrlX Oscilloscope app, at the same time. This is where I am having trouble.

yzpguest · ‎05-27-2024

I briefly activated the motion and used an oscilloscope to record the data. The results clearly show a delay of five cycles in the feedback. This observation suggests a lag in response time during operation. I've been collecting data on the Rexroth drive with an oscilloscope, and the results appear completely normal. However, I can't help but suspect that the use of the ctrlX X2 device might be causing issues. This problem has been bothering me for several days to the point of questioning everything. Could you please assist me? Thank you.

yzpguest · ‎06-07-2023

Could you please guide me on how I can obtain this version of ctrlX CORE? Whether there's a download link I could use or a specific process I should follow, any assistance would be greatly appreciated. Thank you in advance for your support and guidance. I look forward to your positive response and to being an active member of this innovative community.

About yzpguest

Re: Oscilloscope APP shows delay in signal tracking

Why does Ctrlx communication delay by 5 cycles?

Re: Subject: Why is there a five-cycle delay in motion?

Subject: Why is there a five-cycle delay in motion?

Re: EtherCAT app in Simulation