FORUM CTRLX AUTOMATION
ctrlX World Partner Apps for ctrlX AUTOMATION
- About Jesse
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
About Jesse
since
10-22-2020
yesterday
Jesse
Established Member
35
Posts
0
Likes
3
Solutions
03-17-2023
03:36 PM
Thank you YUL725 for point it out. I could get the drive into AB after manually switched the XM to BB and run some plc open commands. normally C450 is set as 4(BB) and I didn't check it and it was set 2(P2). however after I set it to BB. the sercos is getting into BB and shows no error, but the drives are still in CM mode and don't automatically get into BB. now I need to manually switch the phase from drive side. I cycle the power few time times and nothing changed. the drives are configure to run into run mode automatically after sercos in BB. see some screen shots below. there is another issue I want to mention here. if the parameters are changed in drive from CtrlX drive engineering it won't automatically update the same parameters in the controller or vice versa. have to make sure the parameters the same at both sides. I don't know if there is a plan to make the parameters updated at same time on both sides automatically.
... View more
03-16-2023
04:58 PM
I have been testing a XMD with a XM21 on sercos. looked like there is communication issue between XM21 and XMD on sercos. Indraworks used was V15 and CtrlX drive engineering was V118.1. no matter I powered up the drive first or XM first. the XM always stayed at P2. the power control of the drive was setup as below and wired BB to XG31.3 and use XG31.8 to turn on the power for second axis. the only way to turn on drive to AB was to manually switch the sercos to BB without a program. there was no error showed. is that normal or did I miss any setting caused this issue? your help is appreciated. Thanks,
... View more
- Tags:
- ctrlxdrive
- MLC
12-08-2022
02:16 PM
Thank you for answering that. I was wondering if there were something I did wrong. let's wait an update on that.
... View more
11-28-2022
03:09 PM
we got a demo of CtrlX Core X3 with profinet slave ports at xf-23 and xf24. the profinet device app and other apps (version 1.16)were installed and licensed. after having XF23 port configured as profinet device and running the transition status is always at Safe-OP mode.
when checking the scheduler it shows operating.
since the CtrlX I/Os have not been installed yet the Ethercat Master has an error "Topology not OK"
this is the first time to test X3. does the Ethercat master error affect the profinet status?
then I set up a XM22 as profinet master and loaded the device data file. the master can have the device scanned. after having the settings applied in the project and downloaded it showed module not found.
from that I can guess the issue is from the CtrlX core X3, but after having most settings checked I haven't seen where to change the profinet settings and how to fix it. let me know if I have missed any settings.
your help will be appreciated.
... View more
OK
OK