About Jochen_Mueller

Jochen_Mueller · ‎10-05-2020

Hello Please check following points boot up the ctrlX CORE add ethercat master save the configuration open IO ENGINEERING from Web-Browser link try scan again. (hopefully now succesful :-)) If you have any problems after this, please leave us a post. Regards, Jochen

Jochen_Mueller · ‎09-01-2020

It is possible to use the ctrlX virtual inside VirtualBox. But it is very performanceless, because of the missing hardware acceleration. So if customers don't need performance they can use the virtual control inside VirtualBox.

Jochen_Mueller · ‎09-01-2020

The access should be regulated by the user management of the ctrlX.

Jochen_Mueller · ‎09-01-2020

Hello Brian one big point the the RM 20.07: We have only one app-file for the real/virtual control. Means you can use the same file to install e.g. motion/PLC/.... either at a real ctrlX or at the virtual ctrlX. After updating the ctrlX apps you should be able to use the AxisInterface tempalte without error messges.... Regards Jochen

Jochen_Mueller · ‎07-10-2020

Hello to connect PLC Engineering with the control you have to insert the IP adress. Attached Screen shows the connection to a virtual control, but it's the same with a real control. (see video ctrlX Automation Application Workshop "MyFirstRobot" at 1:04:48) Further Steps to analyse your problem: Can you ping the control? (VPN?, Multiple Lan Connection?, ...) Do you open the project from the control itself (from Web-Interface) here normally the communication settings will be done automatically the PC? here you have to insert the IP adress

About Jochen_Mueller

Re: ctrlX drive scanning of Ethercat failed

Re: How to run a ctrlX CORE virtual inside a virtual machine (VM)

Re: datalayer access

Re: Snaps for ctrlX CORE Virtual RM 20.07

Re: Communication setting in ctrlX PLC Engineering