Representation of the Torquevalue in Runtime V3.08 and V3.12

[JohsH]

Hello all,

I wonder why the Torque-values ( and Power-values)  are represented as shown: see attach.

Also with default.par. Even by changing the resolution ( by 'scaling extended') from default 0.1 to 1

Runtime V3.08 or V3.12 do have the same issue .  Unfortunatly i cannot sent a .par as attach

[Drives_Uwe]

The screens you show are only telling the maximum possible values for power or torque but the resolution is as set either by the prefered scaling or by you, user-defined.
Mind that usually the maximum values presented are limited by e.g. the motor or drive size, so parametters like S-0-0092 show a much lower value (in your case only 319,9% instead of the 3276,7 %). So always look on the parameters directly.

[JohsH]

Hello

Also S-0-0092 had the value from 3276,7 %.     And a power limit from 2 147 483 647 W wil gain qustions at the customer.

Will it be solved in a later version?

[JohsH]

Hello

Also S-0-0092 had the value from 3276,7 %.     And a power limit from 2 147 483 647 W wil gain qustions at the customer.

Will it be solved in a later version?