P-0-0300: I/O Engineering startup parameters

[Obel01]

Hello, 

I would like to set the parameter P-0-0300 by I/O Engineering  startup parameter. 

i used a syntax list as shown in the attached screenshot. 

My problem is : the drive doesn't switch to OP mode  when i add this line in the list of parameters. 

I dont' know if the syntax is correct or not, are there any solutions to this problem? 

thanks a lot, 

 

[Nathanael]

Hello,

Yes, very good question indeed.

I have same problem to solve... ☹️

[CodeShepherd · Accepted solution]

Could you tell us which device you try to write this parameter to? It looks like some drive (HCS) but not an ctrlX IO. So I can move it to the correct sub forum.

P-0-0300 is a 4 Byte variable list so parameters would be e.g.

• S-0-0402 = 0192_HEX = 16#01, 16#92
• P-0-0223 = 80DF_HEX = 16#80, 16#DF

We will check this in the next days.

[Obel01]

Thanks for your reply, 

I would like to write this parameter into indradrive_MPE20 by startup parameters.