About stefanAT_ctrlX

stefanAT_ctrlX · ‎08-02-2024

Thank you for this function ! I just used it. Works fine. I had some troubles first because I used the wrong iq-text... Therfore for beginners like me 🙂

stefanAT_ctrlX · ‎05-24-2024

You are right. The proper firmware has to be loaded before to the panel. If you have just one firmware version then it's easy. Just load the firmware on to the panel and use it. The firmware can be found on the Collaboration room !!! But backup/restore without PC is not possible if you have to use different firmware versions.

stefanAT_ctrlX · ‎04-10-2024

Hello @JLG_War, you mean you write from your PLC via a bus on the S-145. And the S-145 you use on the local IO of the ctrlX DRIVE ? ctrlX DRIVE (or IndraDrive ?, which Firmware ? ) .

stefanAT_ctrlX · ‎04-02-2024

Thank you Gunnar !

stefanAT_ctrlX · ‎04-02-2024

In the project planning at the power dissipation data for e.g. XMS devices there is written that also the control unit section in the drive has to be added for the total power dissipation. Where to get the data of the control section (in the past we heard we should take it as from IndraDrive). Are there some news ? Regards, Stefan Svoboda

About stefanAT_ctrlX

Re: Integer in hex notation?

Betreff: CtrlX Drive Panel Backup Restore Functions

Betreff: Drive parameter S-0-0145 gets overwritten to 0

Re: Power dissipation data of control unit in ctrlX DRIVE

Power dissipation data of control unit in ctrlX DRIVE