About stefanAT_ctrlX

stefanAT_ctrlX · ‎03-01-2023

Here you will also find this info (an example). In the Datalayer you will find the IOs also without PLC App. But to use it in the PLC that helps: https://developer.community.boschrexroth.com/t5/Store-and-How-to/Set-up-WAGO-I-O-System-750-and-connect-it-to-ctrlX-CORE-using/ba-p/46130 See Point 3) and 4)

stefanAT_ctrlX · ‎03-01-2023

Hello @TBauer , have you seen this How-To ? https://developer.community.boschrexroth.com/t5/Store-and-How-to/Set-up-a-ctrlX-CORE-amp-PLC-Programming/ba-p/25722 Yes, for EtherCAT you need the IO Engineering . In the PLC ENgineering you have to click with right mouse button on the datalayer to edit the entries. The ypu will see the %IX... and so on:

stefanAT_ctrlX · ‎02-28-2023

Hello, I have a XCS with an external brake resistor and a MS2N motor. The maximal DC voltage adjustment for the motor is 950V (P-853). On the DC-Bus we have also an external equipment (load) which works with maximal 800V DC. Therefore I want to limit the DC output of the XCS drive. I can adjust the switch on limit for the resistor (P-834) to e.g. 730V but the P-853 (I adjust to 790V) will be set automatically while switching to OM to 950V (from the motor /encoder feedback). What can I do. Regards, Stefan

stefanAT_ctrlX · ‎02-23-2023

Hello, is it possible to install ctrlX WORKS via command line ? I mean an automatic installation on some PCs with a command so that the IT-admin has no to much to do with that.

stefanAT_ctrlX · ‎02-17-2023

Thank you for the informations ! Oh, yes, I was wrong, I thought to collect data from different devices. You are right, the ctrlX has to be the controller. Or the S7 has to be the Profinet controller and the CORE the device. We check with customer.

About stefanAT_ctrlX

Re: How to connect Variables to I/O?

Re: How to connect Variables to I/O?

maximal DC Voltage at XCS

ctrlX WORKS installation via command line

Re: Fast reading of data via PROFINET into ctrlX CORE and send it to a database in a fast ...