About giustola69

giustola69 · ‎09-01-2021

Hello, I created a new virtual machine on lìthe last CtrlX sprint I configurated the axis a nd a kinetamic but I could not get online with the PLC application ( also a newone ) . In the attached screenshots the configuration and the log in error message. In the zip file the information Please could you give me some tips about how to log in ? Many Thanks Giuseppe

giustola69 · ‎07-22-2021

Hi, I did not stop the scheduler before. Now I tried it again and the Reset command was OK and after that it was also possible to switch the motion to operating mode Many Thanks Giuseppe

giustola69 · ‎07-22-2021

Hello, I tried to do what you suggest but I got and error while doing the Reset command. I tried it on the Virtual Machine I had and I got the 1st errors, then I deleted that virtual machine and create a new one and then tried again to to the Reset command but I got a different error. However in bith case it was not possible to end the Reset command. Any other advice ? Many Thanks Giuseppe

giustola69 · ‎07-20-2021

Hello, I'm trying to configure an axis in a new virtual machine created with Ctrl Works 1.10.3 but I could not switch the motion from configuration to operation. Attached you have the configuration I did and the messages I get. If I start an old virtual machine made with CtrlX Works version 1.6 it works Please could you help to to understand why? Many Thanks Giuseppe

giustola69 · ‎07-19-2021

I updated to the last available versione 10.0.3 I got today and using the 127.0.0.1:8740 address I could connect again the the Virtual machine Thanks

About giustola69

Couldn't go online with the PLCapplication on a new Virtual Machine

Re: Error switching motion fron configuration to operation

Re: Error switching motion fron configuration to operation

Error switching motion fron configuration to operation

Re: Communication with Virtual machine not running after updateing to Ctrlx Sprint 1.10