About Open

Open · ‎09-01-2022

Hello CodeShepherd, I am using ctrlX PLC version 1.14.1 and CXA_PLCopen library 1.14.0.1 This error only happen sometimes and sometimes after a power cycle it worked normally. I tried to replicate the error however it works fine now.

Open · ‎08-29-2022

Hello Community, I am using ctrlX drive demo unit with PLCopen library ladder programming, When i used MC_Power function block whenever i logged in it will show Error, i tried resetting Warm, Cold and Origin still the same. But however when i use structured text it has no issue. Anyone encounter the same issue? please see attached.

Open · ‎08-29-2022

Hello Community, I am new to Modbus TCP App, I am using S20-ETH-BK and S20-DIDO-8/1, I am testing ctrlX Modbus TCP App to write to digital output, but however the digital output LED indicator did not light up. Below is my setup. Plug & play is disabled. Designation "D" is flashing green - ctrlX Modbus TCP App setup I am unsure if it is because my S20-DIDO-8/1 designation "D" is flashing green or my setup is incorrect. Hope someone can advise me. Warmest regards,

Open · ‎08-18-2022

Hello maurusbien, Try assigning ETH1 and connect your cable to ETH2 in WR21.

Open · ‎08-17-2022

Hello, I had the same issue with my ctrlX drive demo unit too, after upgrading to version 1.16 the ctrlX flashes yellow and prompting me to change battery. After i changed the battery it still flashes yellow and prompting me that my battery level is low. Warmest regards,

About Open

Re: ctrlX PLCopen library Ladder Error

ctrlX PLCopen library Ladder Error

Modbus TCP App issue.

Re: Static IP Address WebPanel WR21

Re: Suppression of warning yellow LED on ctrlX CORE X3