About RGrieger

While I was testing a ctrlX CORE as an Ethernet/IP adaptor, I closed all my ctrlX software to load our VPN and check my e-mail. Then I closed the VPN and launched ctrlX Works then connected to my CORE again. When I tried to launch the logic editor for my ctrlX PLC, I saw this for a minute: Then this fault window comes up in Deutsch:    Restarting and cycling power did not help. Creating a failure report does not work. If I close the programs and try to launch the ctrlX PLC Engineering directly from the start menu it gets the same fault.  I tried to delete "C:\ProgramData\AP\PlugInCaches\Studio-xxxxxxx.cache" and that had no affect.  A cold start on the PLC seemed to succeed, but I still can't get past these error messages to see the logic editor. Please offer me some troubleshooting ideas. Thank you, Bob Grieger ... View more

I am trying to add the IDE app to my CORE so I can learn Blockly.  I have been running versions 21.03.2 and 1.8.3.  My CORE was controlling my Cs drive via PLC code for the past week.  I have stopped the PLC app.  I wanted to try to control the drive with Blockly so I am trying to install "IDE IDE-V-0108.0.arm.app" I downloaded the app on 5/19/2021 from the ctrlX collaboation site.  I am in service mode when I try to install the app and I always get a fault that reads "Upload failed! Assertion file missingin app bundle for architecture arm64 One of the provided arguments is invalid"(picture attached).  I have the python runtime succesfully installed already.  My hardware is R911406308 AB1.  Please offer me any suggestions you may have to eliminate this install fault. ... View more