About StefDu

StefDu · ‎09-18-2024

Hello Brian, an automatic discharging of the DC-bus is not possible during F88xx errors. Only the power is switched off. Can you please share your scope file for evaluation after you created it? The error reaction in the drives is set to NC-reaction? How is the Bb signal of the power supply provided to the drives? do you write S-0-0240 bit 0 over digital input direct from the power supply or over master communication. Is the bit 15 of S1720.0.2 used as Bb signal? regards, Stefan

StefDu · ‎04-16-2024

Hello Dave, you can download the documentation here: https://www.boschrexroth.com/media/c881e187-2fcf-442a-9d17-53289ec12d81

StefDu · ‎04-15-2024

Hello, It seems that the device has an internal defect: In the error log file is a F4036 "Disturbed internal communication with communication module". Please get in contact with the service department or your local sales department and exchange the device.

StefDu · ‎03-15-2024

Good morning, when you enable a command via parameter editor, you have to use both bits. But over the signal control word one bit will activate the command. When you parameterize two bits of one command in the signal control word you will receive C0242 Multiple configuration of a parameter -> S-0-0423 in Parameter S-0-0027. regards, Stefan

StefDu · ‎03-14-2024

Hello, you can set the absolute position (command C0300) by configurating S-0-0447 in the signal control word. regards, Stefan

About StefDu

Re: XVR error reaction to F88XX

Re: ctrlX DRIVE STO manual

Re: F4039 Communication return with enable signal set

Re: Set absolute position for encoder:C0300 Command Procedure with Profinet PLC

Re: Set absolute position for encoder:C0300 Command Procedure with Profinet PLC