Managed to get it solved by clicking the "Add Library" tab under Library Manager , go to "advanced" and search for the the feature that you wish to import into the library.
... View more
Hello,
by operating with WD you avoid the topic. Means the WDs - even with expanded setups - will provide more access of the ctrlX.
Running the system without WD into a endless-loop will cause high load on the core the PLC-Task is calculated and all task with lower-Prio will be suppressed. Communication of the web-sites is effected etc. Trying to get in contact with the ctrlX-PLC Eng will run in Timeout-topic. Goal would be natural to bring the PLC in Stop. Remember the Endless-loop is not a bug in terms of system-behaviour. If a) the PLC-website can not be loaded, b) the PLCEng is not connectable the Rest-Api be supported. If not - the deactivation of the PLC-App will be possible, even several trials may be needed to trigger the switching to 'Service' - mode. Activating the PLCApp again will bring the PLC in Stop-mode. Low load will the result - connecting with PLCEng is possible again. Flashing the image can be avoided by that!
If the above is not feasible:
Sending the control for service can be avoided just by re-flashing the ctrlx-runtime - image again (system-apps). Placing a microSD with the Image makes the ctrlX to 'boot' with external memory content.
The topic is described within the release notes or https://docs.automation.boschrexroth.com/doc/3417946415/hardware-reset-of-the-ctrlx-core-and-the-ctrlx-drive-plus-with-integrated-ctrlx-core/1-06/en/
Bye
... View more
The actual limit, as mentioned above, is 1mV steps. This cannot be decreased.
For example: value => output 1 => 0,001V 10 => 0,010V 1000 => 1,000V 2000 => 2,000V 3542 => 3,542V
... View more
When you connect the ground of an external 24V power supply to the ground of the bus coupler/power module the IO is connected to, you can:
leave U P open and use the external 24V as input to DI IN.
(not recommended) leave DI IN open and use U P to supply externals as long as you keep the current values as low as needed. Beware that there is permanent fuse inside to prevent over current. But it would be easier to use power supply also connected to your bus coupler/power module.
... View more
