About Olorin

Olorin · ‎03-12-2024

Hello All, When I try to use the ctlx Motion Interface on version 2.4 PLC I can only get the first 2 axies to appear. There is a fault in the motion interface program with error ID 4 ACCESS_ERROR, Error Ident CXA_TABLE, Additional info 16#80010001. When I try to reset the error it presists and does not get out of state 4, STATE_INIT_RUN. Any ideas?

Olorin · ‎03-12-2024

Hey Mike, I had to do a clean install of the OS (from SD card) then load the PLC program from a download and not a restore and it worked Hope this helps

Olorin · ‎02-21-2024

Hello, We have switched off on the same issue, it is the boot application, any other reason this could occur? Could a missing node in the datalayer cause this?

Olorin · ‎02-05-2024

Thanks for the response. For the record this was for a machine builder client who would rather not have to keep re-compiling their realtime app for different versions of the OS,maintian multiple bundle activation and cmake files, and retest on each OS build. Many of their client's IT departments have OS version requierements for Linux. This means if the client's customer wants to update the ctrlX OS then the client would have to send them a new snap with their RT-app in it, instead of just having the client downgrade the automation core and keep the OS update.

Olorin · ‎01-30-2024

Is it possible to use an older version of the automation core on a newer CtrlxOS release. For example could I use version 1.2 Automation Core with version 2.4 OS. The idea is to update the OS without having to update any application built with the RT-SDK so 1 install can go into any CtrlxCore, regardless of the OS version.

About Olorin

Ctrlx Motion Interface

Re: PLC not starting on power up

Re: PLC not starting on power up

Re: Ctrlx Autmation Core

Ctrlx Autmation Core