About Drelax21

Drelax21 · ‎12-19-2022

Hello, we use a core X3 as a profinet device.we first used the XF51 connector and then we tried the XF10.with both connections we have the problem that the Profinet connection is temporarily lost after a few minutes for some secends. It would be nice if a solution was found quickly, thank you.

Drelax21 · ‎12-12-2022

Hello, I am using the core as a device, but I need other data types such as INT, STRING.It would be easiest if I had 100-200 bytes of input and output to choose from.Unfortunately I can only select the ones in the picture kind regards.

Drelax21 · ‎12-07-2022

Hello everyone, is there a way to get a biger selection of input and output variants? I tried to change the inputs via the CSV file but this does not work. thanks in advance for the reply.

Drelax21 · ‎12-01-2022

Hello. we are trying to publish 11 values, which are read out by Beckhoff terminals via EtherCat, via the node red app. The interval varies between 30 and 3000 ms. The publish interval is set to 20 ms. In addition, the ControlX hangs up at irregular intervals. We assume, that we made an error in the pre processing of the data flow (see attachments), but we can't identify the real cause. In the end, we are trying to achieve an interval time of around 10 ms. Is this theorethically possible? Thank you in advance

Drelax21 · ‎11-23-2022

Hello @Marc_Smaak Thank you for your answer.I assigned the IP statically and also entered our gateway of the fierwall. the eth1 interface is not connected. to my wiring of the network,I go from the XF10 to a switch and my PC and the network also go to this switch

About Drelax21

profinet connection not stable

Re: selection of input and output

selection of input and output

inconsistent publish rate of the node red app

Re: Core Doesn't work when it's on the network