About YUL725

YUL725 · ‎09-06-2024

Customer is using now third party PC since we could not deliver VR and has not come back to our products. I will however ask when I visit them this fall if this happens again or if the just got used to this.

YUL725 · ‎08-26-2024

Hello Michael, thank you, I tried and if I use only Probe 1 only probe 1 related parameters are required. It would be nice to check only needed parameters depending on var-input of the fb.

YUL725 · ‎08-23-2024

Hello, I need to configure the touch Probe but the Fb reports an error during Configuration, I cannot figure out what is missing (Axis reports Standstill) FB Config : Here is the cyclic Data configuration MDT : AT: Thank you!

YUL725 · ‎05-24-2024

Hello, We have an application that was developped outside the ctrlX system with WebIQ 2.15.9 and now we have a ctrlX Core for which we want to re-use the code and run the Smart HMI runtime App inside the core. The version of this app is 2.15.7. and is not compatible. Do you have a solution for this problem? Thank you for help

YUL725 · ‎05-16-2024

Hello, My customer wires the Single Phase Cs ( HCS01.1-W013) line to line instead of Line to Neutral. Can this cause trouble ?

About YUL725

Betreff: VR4 Maintained Touch on a button is limited to 30sec

Re: MB_InitTouchProbe config Error in Motion 3.02

MB_InitTouchProbe config Error in Motion 3.02

WebIQ ctrlx Core app version2.15.7 incompatibilty with 2.15.9 version

IndraDrive Cs Single Phase : Line to Line allowed ?