About cc2go

cc2go · ‎10-26-2023

The Profinet Device on XF23 and XF24 is a dedicated Profinet Stack, the CodeSys Softstack cannot be assinged to this interface. To use data from the XF23 and XF24 Profinet Device, you have to add via Data Layer Realtime within the PLC. You can add the Data Layer nodes and exchange data via this way easily. Hope this answer your doubts.

cc2go · ‎10-24-2023

Hi, can you please check with ctrlX IO Engineering, when Online the Diagnosis Tab of the EC Device AES-d-bc-ecat if you get more details. Do you tried to add manual? With the diagnosis codes of the AES-d-bc-ecat you should ask the manufacture of the EC device, because the diagnosis seems a configuration issue of the device

cc2go · ‎10-18-2023

With which tool you tried to set? When tool and controller support it, you can change it. current supporting tools are TwinCAT or Omron software, new value need to be written and than the device need a power cylce to apply the new address

cc2go · ‎10-05-2023

Hello, with which commands and data you tried to receive data from the camera? Do you tried with any other tool successfully before, any experience? I'm doubting that plain TCP/IP is possible, because of the following text of the docu "The IV/IV-G Series operates as an EtherNet/IP communication adaptor or a PROFINET communication I/O device. With EtherNet/IP communication or PROFINET communication, the control output signal and status result, etc., can be input to the PLC as communication data."

cc2go · ‎09-18-2023

Hello Venzi, please see this post regarding the XB-EC-12https://developer.community.boschrexroth.com/t5/ctrlX-I-O/ctrlX-IO-XB-EC-12-not-connected-state-at-EtherCAT-master/m-p/81533#M451 Regarding the other issues, try to start with the setting "Slaves have to reach master state" and check than the Bus Diagnosis of the EtherCAT Master, may you find the conflict if not share this diagnosis.

About cc2go

Re: ctrlX Core as Profinet Slave with Codesys Prof...

Re: Connecting Aventics Valvesystem to ctrlX CORE

Re: Use CtrlX IO Engineering to change EtherCAT A...

Re: Connection between CtrlX and Keyence IV3-400CA

Re: installing analog I/O modules from Rexroth