About Tasty_Tech

Tasty_Tech · ‎03-14-2024

Hello Stefan, Thank you for your reply. I tried with that yesterday to set the bit 0 to 1 manually to test from the parameter editor, it did not initiate the procedure, but when i changed the bit 0 and 1 to 1 then it initiated the C0300 procedure. Please find the video attached. So is it that i need to add another bit in the control word and enable both the bits one by one from the profinet PLC? Please let me know if my understandin is not right. Thank you

Tasty_Tech · ‎03-13-2024

No, the control is done via EtherCat from the Core. They just want to access the drive to monitor few things from the Drive engineering application. The EOE through CtrlX Core. Thank you

Tasty_Tech · ‎03-13-2024

Hello Team, I want to set absolute position for encoders in the ctrlX drive using 3rd party profinet PLC. Could anyone help me how this can be done? Thank you in advance

Tasty_Tech · ‎03-12-2024

I think found another solution as the core 2 is being overloaded because we are accessing the drive throught the core over the EtherCAT. So we can use EoE to access the drive so the core 2 is not overloaded. Would anyone like to comment on this? Thank you

Tasty_Tech · ‎03-11-2024

The increase in the usage of the core and overloading, this happens when we try to access the drives from the Drive engineering via the core. So do we have a solution for this?

About Tasty_Tech

Re: Set absolute position for encoder:C0300 Command Procedure with Profinet PLC

Re: CtrlX Core X3's Core 2 increases the usage

Set absolute position for encoder:C0300 Command Procedure with Profinet PLC

Re: CtrlX Core X3's Core 2 increases the usage

Re: CtrlX Core X3's Core 2 increases the usage