About V_A

V_A · ‎07-12-2023

Hello, When starting the CtrlX7, 2 faults are always displayed. Error during automatic reallocation of the callables Failed to create a callable (extending programs) factory: "plc-sched-state", task: "" ("SCHED_E_INVALID_ARGUMENTS") Failed to create a callable The desired task is not available task After I delete the fault, I can start the PLC app normally again. However, the errors appear again after I switch the system off and on again.

V_A · ‎07-07-2023

Hello, I'm trying to replace a CtrlX3 with a CtrlX7. After creating an ethercatmasterl and loading the topology from the IO engineering, I get an error message that the topology is not ok. However, nothing has changed in the other topology and the status in the core shows everything with green ticks. What is the correct procedure in this case?

V_A · ‎07-07-2023

Hello, I have a project for a CtrlX3 controller in plc and would like to load this project 1 to 1 into the CtrlX7. What is the easiest way to do this?

V_A · ‎07-06-2023

How can I update the system and where can I get the recommended version? I only found the CtrlX Works version 1.12.10 under the link. https://www.boschrexroth.com/de/de/myrexroth/collaboration/collaboration-rooms/?path=/Ctrlx-Automation/ctrlX_eShop/ctrlX+WORKS+Engineering

V_A · ‎07-06-2023

What do you mean by version? If you mean ctrX Works, then it's 1.12.4. Unfortunately I don't see the place where the software version of the CtrlX is. I've attached a picture of the two controllers. The "Setup" option is only visible in the settings for the CtrlX7.

About V_A

Error when starting CtrlX after updating from CtrlX3 to CtrlX7

Ethercatmaster Topology not ok ctrlx3 to ctrlx7

Change arm64 project to an amd64 project

Re: CtrlX7 EtherCat Master app installation failed

Re: Hardware exchange from CtrlX3 to CtrlX7