Profinet interrupt when an Axis error

[85029794]

Hello,

Is there anyone have experience about this problem，

hardware: COREX-M-X3-11-B1NN-21.01-01RS-NN-NN 

software: CtrlX PLC APP:1.20.4& Codesys softmotion 4.13.0.0

CtrlX X3 as a Profinet device，Profinet master is a XM  and 8 third part servo via EtherCat COE ,

when an axis error，Profinet was interrupted at the sametime ，but this no error message in PLC engineering and CrtlX ，on the Web， Profinet Device show “OK" , everything seems no problem.

Axis error could be reset in PLC program but Profinet will never recover and have to reboot the CTRLX.

[85029794]

Additional information: 

switch to “setup” or “service”mode，CtrlX occurs an error with timeout

[CodeWasi]

Hello,
what about the PROFINET Device-app. Please check if you operate with the newest PND-V-0120.6.app.
Could you please powerup the ctrlX and check the scheduler setting. Any Placeholder_ lines in ctrlX_automation remaining ?
Bye