Motion app hangs in Configuration/Running after booting

Hello,

without any change in motion app / axes profile since some days motion app is hanging in Configuration/Running. The only way is to set it to running manually. Then everything is working fine till next time of booting (restart, shut off/on).

The only thing which was changed at the ctrlX was adding a SD-card and doing some PLC code changes. But these don't have this effect.

Diagnostic:

Axes

I tried to activate trace but it is not possible to set variables to true....wether in setup nor in service mode.

Installed apps:

 

Best reply by CodeShepherd

This issue will be fixed in the next version 1.18 coming up end of November (RM22.11).

View original
10 replies